Free tools / Loudness normaliser

get the level right

Loudness normaliser

Drop in a take to measure its loudness (LUFS) and true peak. Pick the level the client asked for and save a copy at that level. It only turns the volume up or down, so your performance sounds exactly the same.

Your file is read and processed on your device. It isn't uploaded anywhere.

Target level

Common targets

Sources and what they're for are in the guide below. If the brief gives a number, type it in.

LUFS and LKFS are the same unit with different names.

your take

Choose a file to measure it.

How the normaliser works

It measures the take's integrated loudness, the average loudness of the whole file as a listener hears it, using the method in ITU-R BS.1770 (K-weighting, 400 ms blocks, and gates that leave out silence and very quiet passages). It also finds the true peak, the highest point the waveform reaches between samples, by looking at the audio at four times its sample rate.

Then it works out how much to turn the whole file up or down to hit your target, and applies that single change. It doesn't compress or limit, so the balance between your loud and quiet moments stays exactly as you performed it. The "After" numbers are measured again on the new audio, not just predicted.

A mono file is measured as a single channel. Everything happens in your browser; your file isn't sent anywhere.

When the peaks get in the way

Turning a take up raises its peaks too. If reaching the target would push the true peak above your ceiling, the normaliser tells you and stops at the highest level that stays under it. It never lets the audio clip. To get all the way, you'd need a limiter in an audio editor, which changes the sound a little, so check with the client first.

The common targets

  • EBU R 128, −23 LUFS, true peak no higher than −1 dBTP. The European Broadcasting Union's recommendation for broadcast programmes. EBU R 128 (version 5, November 2023).
  • ATSC A/85, −24 LKFS, true peak below −2 dBTP. The recommended practice for US television when there's no other agreement between the parties. ATSC A/85 (July 2026).
  • Apple Podcasts, around −16 LKFS (±1 dB), true peak no higher than −1 dBFS. Apple's audio recommendation for podcasts. Apple Podcasts audio requirements.

Checked on 24 October 2026. Specs change, and many clients have their own, so the brief always comes first. If it doesn't give a loudness, ask.

Audiobooks are different

ACX asks for an RMS level range, a peak limit and a noise floor rather than a LUFS target. The audio file checker has an ACX preset that checks those.